Displayboards - MicroTab
Comprehensiveness and Simplicity
MicroTab LED is the ideal choice for those looking for a single display board, but with numerous capabilities. And for more complex display tasks, it can be connected very easily with other modules.
The light-weight and compact chassis make it easy to transport and install.
Controlled via Microgate chronometers or via PC, MicroTab guarantees full compatibility with the mayor chronometers available on the market.
In connection with timing equipment and pre-installed programs, MicroTab can display the following:
- names (athletes, horses, boats, etc.)
- penalties and scores
- weather information
- time and date
- pre-stored fix or running texts, thanks to the use of the .netBoards software
In combination with Linkgate radio transmission systems the following information can be received:
- timing pulses sent by EncRadio and Polifemo photocells
- display information from Racetime2 and Rei2 chronometers, PCs and LYNX photo-finish.
The display boards can be equipped with plug-ins such as:
- internal battery
- wireless network card
- GPS sensor for perfect time synchronization
- GSM modem (control via mobile phone, SMS, PC)
- 12/48 V switch for external battery connection
RADIO: 5-pole Nucletron connector for Linkgate radio system connection
WLAN: WiFi aerial connector (optional)
LOW BATTERY: Battery status signal LED.
SERIAL1: 6-pole Amphenol connector for serial input/output
SERIAL2: 6-pole Amphenol connector for serial input/output
START STOP LAP INPUTS: 6-pole Amphenol connector for START, STOP, and LAP signals
FUSE: Fuse cavity
SPEAKER: Jack connector for external speaker connection
START STOP: Green START STOP button used for manual START and STOP signals and for modifying values in program settings
LAP RESET: Yellow LAP RESET button used for manual LAP signals and for confirming program settings
POWER: On/Off switch
SUPPLY: Neutrik connector for external power supply and battery charging (if used)
ETHERNET: Ethernet network cable connector
USB: USB cable connector for firmware updating
|Weight||7 Kg (without batteries)|
|Dimensions||96 x 16 x 15 cm|
|Matrix||96 x 16 led|
|Operating Temperature||-20° / +40°C|
|Average Autonomy (at 20°C)||11 hours|